Pyronix Euro 280

Panel Connection – Serial RS232

Manufacturer	Pyronix
Model	Euro
Version	280
Minimum DualCom Pro Firmware	DualCom Pro: V2.24 DualCom Pro 2: V2.0.1
Minimum Panel Firmware	V9.54d
Cable required?	Use the FPRS232 module and use a standard 3 wire cable.
Panel Profile	Pyronix-Euro-RS232
Panel Bus Connection	RS232
Technical Notes	The FPRS232 module can be bought from Pyronix themselves.

Enter “Engineer Mode” > Select “Program ARC/SMS” > Select “Calls”
Set “ARC/SMS” to “Enabled” [0] > Select “ARC Details” [1] and set “Active” to “Yes” [1] > Set
“Format” to “WebWayOne” [141]
Set “SIA Ack Char” [006] > Set “SIA Nack Char” [021] > “Valid Areas” is Engineer’s choice > “Area
Accounts” is Engineer’s choice
Set “ARC Account” to “Site ID/Account No” > Set “Content” [1-32] Engineer’s choice
Set “Redials” [03] > “Set Time Out Seconds” [30] > Set “Test Calls” Engineer’s choice
Exit “Engineer Mode” into “Day Mode”

Go to ‘Set Up Downloading’ > Select “Download” by (WebWayOne) [4]
Select “Poll Timeout” [10] > Select “Modem Init Timeout” [060]
Select “Rings to Answer” [1] > Select “Comm Tx Timeout” [030] > Select “Comm Dial Timeout”
[030]
Select “UDL Tx Timeout” [02] > Select “ARMPC Tel No” (Leave Blank)
Select “Program PCs” [1] > “Modem Tel No” (Leave Blank)
Select “Signal Alarms No” [0] > Select “Signal Faults No” [0] > Select “Signal Set/Unset No” [0]
Enter 1111
Press YES until Program PC 1 and enter 1111 again